Oh, also...

I also ordered one of JAG's dome base plates, so I had to cut the motor shaft down by about 1 1/4".





JAG says the plate is 1/8" thick, so I should be able to replace the center of the 3 nuts on the bolts that stick up from the Rockler into the HDPE ring that the dome is attached to.

Now I just have to hope that the small hex-cap screws that hold the wheel to the cuff won't hit the dome plate. Since JAG said he "had 5 of them" I'd imagine that he has them in hand and it should be arriving soon enough to see...